10¼ inch Gauge
Iron Ore Tippler Wagon
We have one ex-display model - never
run, built Sept 2016,
available now for sale at
£999 (+ VAT) ex works
<< Click here to buy now
Almost 10,000 sturdy wagons, specifically designed by British Railways, were built to carry iron
ore traffic. In the BR era it was found that it was just as easy to empty the wagons by rotating them on a
tippler, removing the need for any doors at all. The BR design is superficially very similar to the 16 ton
mineral with a body 16'6" long featuring clear steel sides braced by channel sections.
However, iron ore is much denser than coal, so the wagons have a smaller cubic capacity (being
about 4" lower than a 16ton mineral), and a higher payload, at either 26 or 27 tons. There are technically five
different diagrams for BR iron ore tipplers, all varying slightly in detail. The first three were built with a
9'0" wheelbase, but on the last two it was increased to 10'0" to improve stability when running. The first 8,590
wagons were built originally without automatic vacuum brakes.
Most tipplers were used for iron ore traffic, and were regularly seen in the Stoke area in block
train working. In 1965, 94 tipplers were branded to be used for chalk traffic, and 91 for sand traffic,
replacing obsolete fleets of older wagons. The absence of doors ensured there were no leaks en route!
In the early 1970s the demand for wagons for iron ore traffic declined and many more of the
tipplers were used for stone traffic, with a distinctive "STONE" logo stencilled on the sides. Some of these
were a feature of the Stoke area too, appearing on the Caldon Low stone trains. Other wagons were converted for
Ingot Mould traffic, carrying large lumps of steel on a bed of ballast.
Our 10 1/4" gauge model is of the
9’ wheelbase version. Reproduced to 2.25" : 1' it is a fairly accurate representation allowing us
to produce a reliable and useable model that still looks just the part. Welded steel chassis and body
construction, with cast resin detail parts, and modern engineering techniques allow this model to be
used on a garden railway or club track alike, whether used in a rake behind a loco or shunted in a yard,
without scarificing detail.
TIG & MIG welded body and
Profile Channel section for chassis
Sprung draw Hooks
Laser cut Underframe gear, brake detail and cast spring detail.
Choice of BR bauxite or BR freight grey paint finishes
Choice of wagon numbers allowing you to build up rakes of wagons
Full 12 month warranty
We will also be pleased to quote for any special ten and a quarter inch gauge parts you may require.
Please feel free to contact us to discuss your project.